Bambulab Tpu For Ams Problem In Ams Bambu Lab X1c Bambu Lab Community Forum

Bambulab TPU For AMS Problem In AMS - Bambu Lab X1C - Bambu Lab Community Forum

Bambulab TPU For AMS Problem In AMS - Bambu Lab X1C - Bambu Lab Community Forum Usually, this problem occurs if the filament configuration profile is not installed in bambu studio. please make sure you are running the latest version of bambu studio, and install the configuration update when the prompt shows up. you can also enable the filament profile from the system filaments tab. thanks a lot. i tried, it works well. While the x1c is direct drive and has no issues with tpu, the ams (before getting to the extruder) acts more like a bowden system. there's a feeder motor similar to an extruder that pushes the filament from the ams to the hotend extruder. it's that pushing from the ams that's the issue with tpu.

Bambulab TPU For AMS Problem In AMS - Bambu Lab X1C - Bambu Lab Community Forum

Bambulab TPU For AMS Problem In AMS - Bambu Lab X1C - Bambu Lab Community Forum As i’ve explained to others, there is some conflict being caused by the bambu studio software. once you’ve closed all of them and rebooted the printer, the conflict seemingly resolves itself. You’ll have to use the external spool holder (the one in the back) for tpu. the ams doesn’t work with tpu, although i’ve seen some info that bambu is attempting to bring out a new tpu filament formula that would allow it to work with the ams. 🔧 having trouble with your bambu lab ams? you're not alone! in this quick vlog style guide, i’ll walk you through a common issue many users face with the automatic material system and how. It turned out that the connector cable between the ams board in the x1c and the mainboard was not fully clicked in. firmly seating it made the problem disappear.

Bambulab TPU For AMS Problem In AMS - Bambu Lab X1C - Bambu Lab Community Forum

Bambulab TPU For AMS Problem In AMS - Bambu Lab X1C - Bambu Lab Community Forum 🔧 having trouble with your bambu lab ams? you're not alone! in this quick vlog style guide, i’ll walk you through a common issue many users face with the automatic material system and how. It turned out that the connector cable between the ams board in the x1c and the mainboard was not fully clicked in. firmly seating it made the problem disappear. So this is my first time trying to print with tpu and when i click send to printer this is the error message i get and below are the tpu settings im using. i’m using bambu tpu for ams. any idea how i can overcome this? update: i tried to print with petg as well and im getting the same message. How many layer changes do you typically do on a print, and what's the highest number of changes you've been able to successfully do with tpu using the ams? i tried printing something in tpu with pla supports with about 1600 layers and filament swaps for the first 300 or so. The problem might be a clogged ptfe tube inside the ams (automatic material system). in this tutorial, i’ll show you how to safely disassemble the ams, remove the clog, and put it all back. This is a known bug in the firmware for the x1c that our team of engineers is working diligently to resolve in the next release. as a temporary workaround, use the following method and you should be able to use the filament.

Bambu Lab TPU for AMS—What Is It Actually Good For?